マルチモデルCプリンロール成形機

No

1

Suitable Material

Colored Steel plate, Galvanized Board

2

Width of the raw material

205-465mm

3

Rows of rollers

13 Rows

4

Appearance size

9800*1850*1750mm

5

Total power

11+7.5KW

6

Thickness of raw material

1.5-2.6mm

7

Productivity

0-10m/min

8

Diameter of shaft

￠70mm

9

Voltage

380V  50Hz 3phases

Manual Uncoiler

Usage:It is used to support the steel coil and uncoil it in a turnable way. The steel coil is uncoiled by hand. Loading capacity:3000KG.Inner diameter: 500-508mm

Main Roll Forming Machine

Material of rollers:45# steel,roller surfaces polishing, hard plating , The polished surface and the heat treatment towards the molds also can keep the molding plate surface smooth and not easy to be marked when it is being stamped.

Hydraulic System AND Computer Control Cabinet

Hydraulic oil: 40#

hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job.

The target piece`s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use

PLC: EURA(Can customize as customer require)

Shearing Mechanism

It adopts the hydraulic drive and automatic location to decide the dimension and cut the target products.

Material of blades: Cr12,quenching treatment

Output Table

It adopts welded steel and supported roller to transmit the products,which is used to collect the finished products.